Skip to content

Removing a Hub or a module

Removing doesn’t destroy a Hub or a module. It unpairs it and deletes its measurements and settings, and you can then pair it again, with the same Hub or another one.

Only the Hub’s owner can remove a module, on the module’s screen with Remove module. The module is unpaired from the Hub, and its measurements and settings are deleted, for example the calibration and the alarm limit. It disappears for every member of the Hub, and the measurements can’t be restored.

At the same time the Hub tells the module to reset to factory settings. If the water level sensor receives this, it resets and the Hub can find it again. It then appears in the list of newly found modules. If it doesn’t receive it, it still considers itself paired. How to tell and what to do is described in the next part.

How to pair a module again or move it to another Hub

Section titled “How to pair a module again or move it to another Hub”

First remove the module from its original Hub. Then add it to the same Hub or another one as if it were new, following the water level sensor guide.

Plug in the charger and watch the sensor’s light. If it stays on in one colour instead of blinking orange, the sensor still considers itself paired. Reset it to factory settings as the Water level sensor troubleshooting page describes, then add it.

When the Hub finds a module that isn’t yet paired with it, the app shows it in the list of newly found modules. It can also be someone else’s module in range, such as a neighbour’s. Reject only hides the module: nothing is deleted and nothing is paired. When the Hub finds it again, for example after its charger is plugged in, it appears in the list again and you can add it.

This part is for the Hub’s owner.

Only the owner can remove the Hub, on the Hub settings screen with Remove Hub. If you’re only changing the Wi-Fi network or moving the Hub within the house, don’t remove it. The steps are on Hub troubleshooting.

Removing the Hub unpairs all of its modules and deletes their measurements and settings. The modules are told to reset to factory settings, the same as when you remove a single module. The Hub’s name is deleted too. All members of the Hub lose access, and pending invitations expire.

You pair the Hub again by scanning the QR code on its back, following Setting up the Hub. Then add each module to it again.

  • Remove module: on the module’s screen, for the owner only.
  • Remove Hub: on the Hub settings screen, for the owner only. A member sees Leave Hub there instead, which removes only their own access.
  • Newly found modules and Reject: on the Overview and Hub settings screens.

Made in EU