Skip to content

Alarms and alerts

The water level sensor watches the level against an alarm limit you set, and it also reports a low battery or a lost connection. Every member of the Hub gets the alerts. How to set the sensor up is on the Setting up the water level sensor page.

The tank type sets the direction of the alarm. For Cesspit, the Overflow alarm watches whether the level has risen to the limit. For every other type, the Low-water alarm watches whether it has dropped to the limit.

Finishing the sensor’s setup saves a suggested limit: 20% of the maximum level, or 80% for a cesspit. You can change it on the sensor’s screen. The alarm starts watching once you finish the setup.

An alert arrives once, when the level crosses the limit. The next one arrives only after the next crossing. Meanwhile the sensor’s screen shows Water running low, or Tank nearly full for a cesspit.

Once the level is back past the limit by at least 5% of the maximum level, a message arrives. It says “Water level back to normal”, or “Tank no longer full” for a cesspit. The alert on the sensor’s screen disappears and the alarm watches for the next crossing.

For Cesspit, a second alert follows the overflow alarm: “Cesspit is full”. It arrives once, when the level reaches the tank’s maximum. The next one arrives only after the level drops by at least 5% of the maximum level and rises again. Meanwhile the sensor’s screen shows Cesspit is full.

The same Alarm on switch and the same notification settings apply to it as to the overflow alarm. It has no all-clear of its own. Once the cesspit is emptied, only “Tank no longer full” arrives.

How to turn the alarm off and keep the limit

Section titled “How to turn the alarm off and keep the limit”

On the sensor’s screen, open Low-water alarm or Overflow alarm and turn off Alarm on. The sensor keeps measuring, it just sends no level alerts. The limit stays saved for when you turn the alarm back on.

If the level is past the limit when you turn the alarm back on, an alert arrives with the next reading.

The limit and the on/off switch belong to the sensor, so they apply to every member of the Hub. Any member can change them.

How you get the alarm and the all-clear is set under Settings, in Notifications. Push notifications go to your phone, Email notifications to your inbox. Both are on until you turn them off. The choice applies only to you, and the other members of the Hub set their own.

A push notification reaches only a phone that has the Hastr app with notifications allowed. To check that one arrives, select Send test push notification.

These alerts always arrive by push and by e-mail, and can’t be turned off.

  • When the sensor’s battery drops to 20%, a “Battery running low” alert arrives. The next one arrives only after you charge the sensor to at least 30% and the battery drops again.
  • When the sensor hasn’t reported for 24 hours, “Water level sensor not responding” arrives. If it last reported the water just below itself, “Water level sensor probably under water” arrives instead. For the Hub, an hour is enough, and “Hub not responding” arrives.
  • Once the sensor or the Hub reports again, “Water level sensor responding again” or “Hub responding again” arrives.

While the Hub isn’t responding, no readings arrive from its modules, and so no level alarm either.

When the water rises to within 10 cm of the sensor, the sensor’s screen shows Water just below the sensor. No push notification or e-mail arrives. The sensor’s signal can’t get through water, so a flooded sensor sends no readings until the level drops.

When the sensor stops reporting after such a reading, the screen shows Water level sensor probably under water. Once the sensor reports again, the screen goes back to Water just below the sensor. That alert goes away once the sensor measures the water at least 15 cm below itself. What to do is on the Water level troubleshooting page.

  • The sensor’s screen: the limit and the alarm switch under Low-water alarm or Overflow alarm. It also shows the alert for an active alarm, a low battery, a lost connection or water just below the sensor.
  • Settings, then Notifications: push notifications, e-mail and the test push notification.

Made in EU